2012-11-21, 04:53
(2012-11-21, 04:30)Specterx Wrote: maybe something with your boblight.conf file. is it set to 300 channels (3 channels per LED)?
Try this calculator for your boblight setup.
be sure to set the column numbers correctly. probably: 32, 20 in your case.
Code:#config file for adalight from http://www.ladyada.net/make/adalight/
[global]
interface 127.0.0.1
port 19333
#speed 75
#interpolation 1
#saturation 2
#value 6
#threshold 50
[device]
name ambilight
type momo
output "com8"
channels 300
prefix 41 64 61 00 32 67
interval 20000
rate 115200
debug off #turn this on to see what it's doing with the serial port
#arduino bootloader runs when opening the serial port for the first time
#delay transmission one second after opening so we don't send shit to the bootloader
delayafteropen 1000000
[color]
name red
rgb FF0000
[color]
name green
rgb 00FF00
[color]
name blue
rgb 0000FF
you need the code above to be on top of the code you get from that web site calculator. Not sure what the prefix line does. but you do need 300 channels.'
give that a try and see what happens.
also check to make sure that the second string of LEDs is connected in the right direction. check the little arrow on each of the LEDs and make sure the output from your first string is going into the end of the second string where they are going into the arrow direction.
What are you doing with boblightd? Which one are you running, and what arguments do you pass to it when you launch it?