2014-01-21, 18:05
Hi! I yesterday got my Lightpack from lightpack.tv and since I use OpenELEC I can't use there Prismatik software, but I have to use the Boblight daemon and addon in XBMC.
I've installed the boblight daemon and add on and used this config file, even though I don't get a rasp pi. http://ajpawelski.wordpress.com/how-to-r...lightpack/
Part of the .conf
What I've tried is to set the blacklevel to like 0.1, that makes the light not go that bright. But other then that, what option shall I try to set in that .conf, and what shall I edit in the XBMC addon?
I've read about some other settings in the Boblight Addon, and I think I start to get it, but does the blacklevel do, and what is that setting called inside the XBMC addon?
What settings should be done in .conf, and what can apps and addons set instead?
Thanks.
/Söder
I've installed the boblight daemon and add on and used this config file, even though I don't get a rasp pi. http://ajpawelski.wordpress.com/how-to-r...lightpack/
Part of the .conf
Code:
#################################################################
[device]
name LP1
channels 30
type lightpack
interval 20000
#bus 1
#address 6
#debug true
[color]
name red
rgb FF0000
gamma 1.6
adjust 1.0
blacklevel 0.0
[color]
name blu
rgb 0000FF
gamma 1.6
adjust 1.0
blacklevel 0.0
[color]
name grn
rgb 00FF00
gamma 1.6
adjust 1.0
blacklevel 0.0
[light]
name L01
color red LP1 1
color grn LP1 2
color blu LP1 3
hscan 75 100
vscan 80 100
What I've tried is to set the blacklevel to like 0.1, that makes the light not go that bright. But other then that, what option shall I try to set in that .conf, and what shall I edit in the XBMC addon?
I've read about some other settings in the Boblight Addon, and I think I start to get it, but does the blacklevel do, and what is that setting called inside the XBMC addon?
What settings should be done in .conf, and what can apps and addons set instead?
Thanks.
/Söder