2014-03-12, 23:24
(2014-03-12, 06:50)nevillebartos Wrote: Hey guys could use a little help getting setup, running xbmcbuntu and at this point I've got boblightd installed as well as the boblight xbmc addon (on same machine). I've used hansaplasts tool to create a config which I then modified to suit 2 lightpacks.
Code:[device]
name AmbiLight
type lightpack
channels 90
interval 20000
serial 95230303231351A07112
bus 8
address 2
debug off
delayafteropen 100000
[device]
name AmbiLight2
type lightpack
channels 90
interval 20000
serial 95230303231351317160
bus 8
address 2
debug off
delayafteropen 100000
I think you have to correct the [device] sections first since they are wrong.
Here's my [device] sections from my boblight.conf file--it is from a 100% working (both Frodo and Gotham versions of OpenELEC!) dual lightpack setup.
Code:
[device]
name LPR
channels 30
type lightpack
interval 16667
#serial 95230303231351A041E0
bus 3
address 3
[device]
name LPL
channels 30
type lightpack
interval 16667
#serial 9523030323135111F1F0
bus 3
address 4
Some mistakes I spotted in your config:
1. There should be only 30 channels per LP. Red, Green, and Blue; and 10 light strips. Each light strip has three LED's, but they are addressed as a single unit.
2. The bus and address of the two LP's in your setup is identical? From looking at your log, you should have one set at Bus 8 Address 2. The other should be Bus 8 Address 3.
FYI, the serial number doesn't seem to work or matter with the LP. I couldn't get everything to work correctly using the serial number--you have to set the correct Bus and Address for both LP's.