[fabiomassimo]

Hi,
I'm using the official xbmc remote control app for iOS and I have found some problem with volume control.
My XBMC is installed on a raspberry pi that is connected to a Onkyo AV Receveir in passthrough.
Through a cheap media center's remote, I'm able to control volume but if i try to control it via the app I get an error because the audio is in passthrough (to decode ac3 and dts).
Is it possible to control volume via iOS app in the same way that remote control works, so I won't get any error?
Thanks.

[Memphiz]

1. Wrong forum - this is about XBMC itself running on iOS (yours runs on RBPI)
2. You should ask your question in the official ios remote thread instead
3. You can just skip 2. because its not possible to control volume in passthrough mode. Whatever the cheap media center's remote is doing - its not adjusting the volume in XBMC (maybe its adjusting the volume on the amp?)