[azrael17]

not sure if i missed something with the last upgrade, if so just let me know.

I performed a new install of 0.4.9 on this weekend and cannot get it started. Tried this on my regular machine and on a new build.

Settings and settings2.xml are from previous installation and have all the proper info. But when i start PSTL is tells me

"Would you like PseudoTv Live to Auto Tune Channels" if a select no - it is gives me an error ""Unable to find channels. Please go to the addon Settinsto Configure PseudoTV Live" select OK and brings up the configuration screen.

Make a few changes, restart PSTV and back at the "Would you like PseudoTV Live to Auto Tune Channels" this time select yes and it goes into a look bringing me back to the same screen.

Log - https://www.dropbox.com/s/cw7odhm6g366bze/xbmc.log?dl=0

thanks.


.......... UPDATE


Luna, I have narrowed this to the settings2.xml file. PSTL goes into a loop when i try to to use it.

Re-installed, let PSTL do its thing ans generate the channels, but when i replaced the file it breaks,

When upgrading, the file is used and the loops occurs automatically.

Settings2.xml file
https://www.dropbox.com/s/s8v8ainfzccqe9...2.xml?dl=0

If it is not picking up your channels it is likely one of two problems:

1) Incorrect syntax, or

2) Non-working or incorrect stream path.


I'm not sure but the ".1" syntax in "Channel_2.1_type", etc, might be causing a problem. All of the examples have used whole numbers, so I would try to rename "2.2", "2.3", "2.4", etc to "2", "3", "4", etc.



Also, should your stream paths be ""/home/[username]/xbmc/Media/OnlineTv/HDHomeRun/2.1 - WCBSDT.strm"?
and
perhaps "xbmc" in the path should be ".xbmc"?

Basically recheck that path to make sure it is correct because there are a few things that don't look like the typical path to me.