[arokh]

I'm at work now, so have not tried it.

As far as i understand it's as simple as set the jumper to configuration mode, insert a USB stick with the *.bio file and boot it up. And then wait for 10 mins. It should take 3-4 minutes, but since we don't se the screen I'l give it 10 minutes. If it requires some key presses I guess some good soul on this site would provide with the correct info...? I will first try the Mini DP, but if that don't work a bios update is my last resort.

I'm positive that the NUC works fine, since it boots up normally. No flashing leds, and USB devices light up too. But the HDMI is the issue, I hope.

I was looking so much forward to this unit, so it bugs me that it won't work. So much for being an early consumer.

Never got mine to work with mini hdmi cable either. It works with a mini dp to hdmi cable but there is no picture until X starts. After X starts and I get a picture, I can reboot and see the entire boot sequence. Might be because I have hdmi as preferred output, but trying to change that in bios causes a crash. Haven't tried with the latest "22" bios.