[speedway]

Hi,

I switched from Windows7 (Frodo 2.3) to OpenELEC (nightly build) and have now one problem at this moment, i.e. after installing
<snip>
EDIT:
Well it seemed my 'advancedsettings.xml' (referring to my sql-library) was blocking the assigment of content to my movie folder.
Since I'm not able to connect to my SQL-DB any more (reason ??) I'll store my movie information on my local drive :-(.

Have you set the setting in the Openelec settings to not start XBMC until the network is available? I ran into the same issue myself and had to use that setting, 10 seconds worked fine and it doesn't usually even have to wait that long. The setting is at the very bottom, you have to scroll.

Indeed, I also found a solution within the OpenELEC forum by using the autostart.sh:
In short:
Create a file called "autostart.sh" in the "ConfigFiles" share, with the following content:
#!/bin/sh
ifconfig eth0 up
ifconfig eth0 192.168.1.97
route add default gw 192.168.1.1
(modify IP addresses to match your setup - 192.168.1.97 = new fixed IP for XBMC box, 192.168.1.1 = your router/modem/gateway)
Reboot box.
Source: http://openelec.tv/forum/112-mysql-setup...mitstart=0

---

Have you set the setting in the Openelec settings to not start XBMC until the network is available? I ran into the same issue myself and had to use that setting, 10 seconds worked fine and it doesn't usually even have to wait that long. The setting is at the very bottom, you have to scroll.

Thx for the information/reply - it is indeed better to do it that way instead of adding the above mentioned line to autostart!

Now, I only have an issue with:
- my bluetooth device (Intel 7260HMW) which isn't found.

I'm using the latest nightly build from OpenELEC.