2014-04-03, 01:39
Hi
I've spent most of this afternoon reading pages on the OE forum about getting an Apple TV remote to work in OpenElec. It's definitely possible and it uses NEC protocol.
I created a keytable to map the controls from the apple remote and put it in /storage.config - as suggested by the post here :
http://openelec.tv/forum/103-infared-rem...rk-with-oe
Then I added a line to my autostart.sh file
Everytime I reboot the i5 and enter
ir-keytable
via SSH, it shows
Start
When I enter
ir-keytable -p NEC, -w/storage/.config/apple
I get
Start
My autostart.sh file reads
Start
Any help please or pretty please?
I've spent most of this afternoon reading pages on the OE forum about getting an Apple TV remote to work in OpenElec. It's definitely possible and it uses NEC protocol.
I created a keytable to map the controls from the apple remote and put it in /storage.config - as suggested by the post here :
http://openelec.tv/forum/103-infared-rem...rk-with-oe
Then I added a line to my autostart.sh file
Everytime I reboot the i5 and enter
ir-keytable
via SSH, it shows
Start
Code:
Found /sys/class/rc/rc0/ (/dev/input/event9) with:
Driver nuvoton-cir, table rc-rc6-mce
Supported protocols: NEC RC-5 RC-6 JVC SONY SANYO LIRC other
Enabled protocols: RC-6
Repeat delay = 1000 ms, repeat period = 125 ms
End
When I enter
ir-keytable -p NEC, -w/storage/.config/apple
I get
Start
Code:
Read apple table
Wrote 7 keycode(s) to driver
Protocols changed to NEC
End
My autostart.sh file reads
Start
Code:
# RGB fix
DISPLAY=:0 xrandr --output HDMI1 --set "Broadcast RGB" "Full"
# IR fix
modprobe -r nuvoton-cir
echo "auto" > /sys/bus/acpi/devices/NTN0530\:00/physical_node/resources
modprobe nuvoton-cir
ir-keytable -p NEC,rc-6 -w/storage/.config/apple
End
Any help please or pretty please?