2014-05-02, 13:14
Ok, I'll stop confusing everyone with the issue regarding two tuners. Perhaps this should in general be handled on a separate thread. Funnily enough, both tuners work simultaneously in r17733 and the xHCI host dies if I try to use both in r17811.
Anyway, test results here.
System: Intel NUC D34010WYK, 4G RAM, PCTV 290e tuner
r17733: No errors seen. Recorded one HD channel and watched another one. Switched on the EPG overlay and tried to goof around in the menus. Not a single error.
r17811: Continuity counter errors and pixelation after a couple of mins watching and recording the same channels while watching the EPG.
Logs here: http://trsqr.net/olli/r17733_logs/ http://trsqr.net/olli/r17811_logs/
If I enabled I2C debug for em28xx module the syslog was full and rotating in about a minute, so I left it out.
Anyway, test results here.
System: Intel NUC D34010WYK, 4G RAM, PCTV 290e tuner
r17733: No errors seen. Recorded one HD channel and watched another one. Switched on the EPG overlay and tried to goof around in the menus. Not a single error.
r17811: Continuity counter errors and pixelation after a couple of mins watching and recording the same channels while watching the EPG.
Logs here: http://trsqr.net/olli/r17733_logs/ http://trsqr.net/olli/r17811_logs/
If I enabled I2C debug for em28xx module the syslog was full and rotating in about a minute, so I left it out.