2014-04-08, 19:47
(2014-04-07, 23:35)sraue Wrote: please try:
Code:modprobe 8192cu
echo "050d 21f2" > /sys/bus/usb/drivers/rtl8192cu/new_id
and paste dmesg, lsmod output and test if the stick will be shown in our connection manager
I've tried the both commands and the wifi adapter gets listed in Openelec settings. When I try to connect it to my WLAN Openelec hangs and I had to hard reset my Pi to boot up again. After the reboot the wifi connection in the settings is gone but this is probably related to the fact that it is a image that was started.
I've searched the logfiles for clues and the only thing I could find are the lines:
Code:
[ 11.973803] lirc_rpi: driver registered!
[ 11.978703] systemd[1]: Started Load Kernel Modules.
[ 11.979681] systemd[1]: Mounted FUSE Control File System.
[ 11.986899] systemd[1]: Mounted Configuration File System.
[ 12.025937] systemd[1]: Started Restoring Backup.
[ 12.073777] systemd[1]: Started Create Static Device Nodes in /dev.
[ 12.140692] systemd[1]: Starting Local File Systems (Pre).
[ 12.140954] systemd[1]: Reached target Local File Systems (Pre).
[ 12.141176] systemd[1]: Starting Local File Systems.
[ 12.141359] systemd[1]: Reached target Local File Systems.
[ 12.141752] systemd[1]: Starting Setup Hostname...
[ 12.145310] systemd[1]: Starting Setup machine-id...
[ 12.160953] systemd[1]: Starting Create Volatile Files and Directories...
[ 12.212153] systemd[1]: Started Setup Hostname.
[ 12.305902] systemd[1]: Started Setup machine-id.
[ 12.365892] systemd[1]: Started Create Volatile Files and Directories.
[ 12.405122] systemd[1]: Starting Update hwdb.bin...
[ 12.413373] systemd[1]: Started Debug /var/log relink.
[ 12.413785] systemd[1]: Starting Journal Service...
[ 12.421446] systemd[1]: Started Journal Service.
[ 12.845347] systemd-udevd[202]: starting version 212
[ 13.329078] Console: switching to colour dummy device 80x30
[ 14.137312] systemd-journald[198]: Received request to flush runtime journal from PID 1
[ 14.641574] pcm512x 1-004c: Failed to reset device: -5
[ 14.641733] pcm512x: probe of 1-004c failed with error -5
[ 14.662687] bcm2708-i2s bcm2708-i2s.0: Failed to create debugfs directory
[ 17.387138] smsc95xx 1-1.1:1.0 eth0: hardware isn't capable of remote wakeup
[ 17.388340] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 18.833358] input: lircd as /devices/virtual/input/input3
[ 18.910085] smsc95xx 1-1.1:1.0 eth0: link up, 100Mbps, full-duplex, lpa 0xC1E1
[ 18.940583] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes readyIs there another location where I can find what went wrong?
