OpenELEC Testbuilds for RaspberryPi Part 2
(2014-04-11, 22:47)MilhouseVH Wrote: Build #0411 updated to #0411b.

Thanks.

Couple of new things to test. The list of refresh rates now contains pal and ntsc variants (e.g. 24 and 23.98).
If most of your content is 23.98 you can set the system refrsh to 23.98 and you won't have the hdmi switching delay when playing most content.

If you set "adjust refresh rate to match video" to always and then play a file with a framerate that changes, or is incorrectly reported in container
(e.g. mediainfo reports different framerate/original framerate because video is 23.98fps, but actual frames are at 25fps) then TV will adjust refresh rate when this is discovered.

This may mean the TV adjusts at start, and then again after few seconds.
There is a chance this could false alarm, so report if any video triggers this when you don't believe it should.

Changing "adjust refresh..." to on start/stop should avoid the new behaviour.


Messages In This Thread
RE: OpenELEC Testbuilds for RaspberryPi Part 2 - by popcornmix - 2014-04-11, 23:08
AW: RE: - by DieterLumpen - 2013-07-29, 20:50
include guires switch? - by hpbaxxter - 2013-08-01, 21:46
RE: dual audio?? - by pootler - 2013-08-03, 17:13
Help, watch 3D Film on Non 3D TV - by unix72 - 2013-08-09, 12:39
Remote Controllers - by tfft - 2013-08-14, 09:11
rbej repeatable crash - by RichG - 2013-08-19, 12:43
New Tester - by theneverstill - 2013-10-03, 17:16
[split] missing subtitle stream - by Jönke - 2014-01-08, 21:03
3D Support - by michbeck100 - 2014-01-11, 01:01
No sound on Gotham builds - by URBANsUNITED - 2014-01-13, 15:19
Logout Mark Read Team Forum Stats Members Help
OpenELEC Testbuilds for RaspberryPi Part 223