[calcon79]

Here are my overclocking settings. I have found if I go higher than this I will get lockups. Especially on sdram_freq and core_freq. Unless I am still too high?

arm_freq=900
core_freq=400
sdram_freq=450
over_voltage=2

I will try increasing memory and setting hvs_priority. I also started from a completely clean slate with Openelec Official 4.0.6. Another issue I noticed that seems to be tied to deinterlacing enabled (OMXPlayer) is sometimes when the audio blanks out when it comes back it is no longer in sync with the video. I also saw some people mention this previously in this thread. They were talking about LiveTV and it so happens my files are all 1080i TV recordings that this is happening to.

Also on another note. I get lockups with the newest Milhouse Build #0703. It was doing it before but I wasn't really paying attention to it. It seems to be related to standby settings. If it sits long enough to go into standby (screen goes dark) instead of going into standby my Pi will freeze up. I see that this has been discussed recently. Maybe there is something I need to disable? Disable standby if I am using Milhouse test builds? I think in my settings I have the screen go dark when the Pi sits for a while.