[allan87]

New settings in system/input/peripherals/cec.

delay: duration before repeating (ms)
repeat: rate the button will repeat at when held (ms)
release: duration after less pressed message until button is considered released (ms)

delay should be set as low as possible, without unwanted double presses
increase rate for faster scrolling of lists when held down. The keyboard in xbmc uses 80ms.
if release is zero, we just rely on the released messages through CEC. Otherwise released messages are ignored and the release will occur after this duration.

I'd suggest trying delay=300, repeat=80, release=0 as a starting point, which works well on my Panasonic.

I tried a few different settings on a samsung C7000 series.

• 200 ms before repeating was fine. I did not see any point trying faster. 300 would also have been fine.
• I went as high as 150 on repeat rate, because I felt the repeat had to be slowed down. Even at 150, the interface lagged behind the button press - although it started to repeat quickly, it didn't start scrolling fast until a fairly sustained button down, and then it significantly outran the button release. I had to get the hang of how it responded, because it would inevitably run past 5 to 10 more items after button release.