2014-06-11, 23:42
Hey Matt
So yesterday I updated the firmware to the then current 2.8. I thought it seemed faster when I booted up after that… which I realized it was faster as it didn’t appear to be going to the boot menu screen for the 5 seconds to give you a chance to hit escape to choose a drive.
So, today I noticed you updated the firmware again so I was going to flash the latest version, but I cannot get to the boot menu (I was actually concerned about this happening after the flash yesterday). It instantly goes into openelec. I don’t seem to be able to choose any other drive… it just goes right into openelec then xbmc…. even if i’m holding down the escape key when I turn on the unit.
So did you change that 5 second time out or did something go wrong when I updated to 2.8 yesterday? It seems like it went fine since xbmc works okay, but I guess not? Am I the only one who had this issue? Thanks.
So yesterday I updated the firmware to the then current 2.8. I thought it seemed faster when I booted up after that… which I realized it was faster as it didn’t appear to be going to the boot menu screen for the 5 seconds to give you a chance to hit escape to choose a drive.
So, today I noticed you updated the firmware again so I was going to flash the latest version, but I cannot get to the boot menu (I was actually concerned about this happening after the flash yesterday). It instantly goes into openelec. I don’t seem to be able to choose any other drive… it just goes right into openelec then xbmc…. even if i’m holding down the escape key when I turn on the unit.
So did you change that 5 second time out or did something go wrong when I updated to 2.8 yesterday? It seems like it went fine since xbmc works okay, but I guess not? Am I the only one who had this issue? Thanks.
