2015-02-05, 01:35
I am using the HP Chromebox.
I have just run through the setup for standalone and now have a problem with no display output from the device.
The install went as per instructions without issue until I attempted to install OpenElec (latest version 5.0.1) installed on a USB device using the supplied batch script supplied with the installation.
On boot I selected the USD drive but the responce from the box was that it could not boot from the device.
Assuming that the installer hadnt been written properly, I shut down the device and recreated the USB installation.
Now the device has no video output on startup so I cannot do anything, including restoring the backed up firmware.
Any ideas??
As a newbie, apolgies if I have posted this to the wrong thread...
Thanks
I have just run through the setup for standalone and now have a problem with no display output from the device.
The install went as per instructions without issue until I attempted to install OpenElec (latest version 5.0.1) installed on a USB device using the supplied batch script supplied with the installation.
On boot I selected the USD drive but the responce from the box was that it could not boot from the device.
Assuming that the installer hadnt been written properly, I shut down the device and recreated the USB installation.
Now the device has no video output on startup so I cannot do anything, including restoring the backed up firmware.
Any ideas??
As a newbie, apolgies if I have posted this to the wrong thread...
Thanks