[Matt Devo]

I am using the HP Chromebox.
I have just run through the setup for standalone and now have a problem with no display output from the device.
The install went as per instructions without issue until I attempted to install OpenElec (latest version 5.0.1) installed on a USB device using the supplied batch script supplied with the installation.
On boot I selected the USD drive but the responce from the box was that it could not boot from the device.
Assuming that the installer hadnt been written properly, I shut down the device and recreated the USB installation.
Now the device has no video output on startup so I cannot do anything, including restoring the backed up firmware.

Any ideas??

As a newbie, apolgies if I have posted this to the wrong thread...

Thanks

there's no reason the box would work on the initial boot post firmware flash, but then not subsequently. Check all connections, disconnect power for 1 min, etc. Try a different display/cable/cable type.