2015-04-11, 07:41
So somehow messed up my HP Chromebox, Openelec install. Had it up and running as a dual boot and decided to change it over to standalone install, that's where am stuck now with the Black Seabios screen. Had installed the custom coreboot firmware, and was rebooting with the Openelec created usb, but only get to the SeaBios screen. No buttons work, tried ESC, Cntl-D, Ctrl-L, etc.
The black screen says:
SeaBios
Booting from Hard Drive...
early console in decompress_kernel
KASLR using RDRAND...
Decompressin Linux...Parsing ELF...Performing relocation...done
Booting the kernel.
[ 0.131208] [drm:1915_write32] *ERROR* Unknown unclaimed register before writ
ing to a090
[ 1.374989] i8042: No controller found
[ 1.376139] gsmi: exec 0xclef: Unknown error 0xclef
[ 1.812159] usb 1-4: string descriptor 0 malformed (err = -61) defaulting to 0x0409
Right now am stuck here with no idea how to solve this. I would like to get openelec installed in standalone mode, or get it back to factory setting and start over again.
Any solutions?
The black screen says:
SeaBios
Booting from Hard Drive...
early console in decompress_kernel
KASLR using RDRAND...
Decompressin Linux...Parsing ELF...Performing relocation...done
Booting the kernel.
[ 0.131208] [drm:1915_write32] *ERROR* Unknown unclaimed register before writ
ing to a090
[ 1.374989] i8042: No controller found
[ 1.376139] gsmi: exec 0xclef: Unknown error 0xclef
[ 1.812159] usb 1-4: string descriptor 0 malformed (err = -61) defaulting to 0x0409
Right now am stuck here with no idea how to solve this. I would like to get openelec installed in standalone mode, or get it back to factory setting and start over again.
Any solutions?