2015-07-26, 16:37
Bear with me please..newbie.
I SSHd into the unit.
I did the following
nano /storage/.config/autostart.sh
Then I typed
(
xrandr --output HDMI1 --mode 1920x1080
)&
THen hit CTRL O to save and then rebooted the machine
It still shows SIGNAL PROCESSING on the projector when it boots up but for about 5 seconds and then goes to "NO SIGNASL " and has no picture. When I go into SSH and type xrandr I get the following
Screen 0: minimum 320 x 200, current 1024 x 768, maximum 32767 x 32767
HDMI1 disconnected (normal left inverted right x axis y axis)
DP1 disconnected (normal left inverted right x axis y axis)
HDMI2 disconnected (normal left inverted right x axis y axis)
VIRTUAL1 disconnected (normal left inverted right x axis y axis)
The weird thing is at one point it was working fine when I first hooked up the machine and it is gone despite the fact that I didnt change anything. I have completely factory reset it now so I dont know what setting I had to make it work before. Why does it say HDMI1 disconnected?
Thanks
I SSHd into the unit.
I did the following
nano /storage/.config/autostart.sh
Then I typed
(
xrandr --output HDMI1 --mode 1920x1080
)&
THen hit CTRL O to save and then rebooted the machine
It still shows SIGNAL PROCESSING on the projector when it boots up but for about 5 seconds and then goes to "NO SIGNASL " and has no picture. When I go into SSH and type xrandr I get the following
Screen 0: minimum 320 x 200, current 1024 x 768, maximum 32767 x 32767
HDMI1 disconnected (normal left inverted right x axis y axis)
DP1 disconnected (normal left inverted right x axis y axis)
HDMI2 disconnected (normal left inverted right x axis y axis)
VIRTUAL1 disconnected (normal left inverted right x axis y axis)
The weird thing is at one point it was working fine when I first hooked up the machine and it is gone despite the fact that I didnt change anything. I have completely factory reset it now so I dont know what setting I had to make it work before. Why does it say HDMI1 disconnected?
Thanks