[Matt Devo]

All standalone:

Matt: I just updated the firmware on my Asus, no problems.
Then did an update on my HP, it now just gives a blank screen through my hdmi switch (which goes to my Pioneer plasma) It works fine if I connect it to my pc monitor. Also works if connected directly to the plasma. (Although doesn't seem to come farther than grub atm)

Any obvious reasons why that is so?


Edit: this happens when I booted with partmagic on my plasma: http://i67.tinypic.com/5d6lgp.jpg (upside down pic, sorry)
This is in 32bit mode, 64bit mode happens to work fine.

Edit2: after a reflash, partmagic works fine in both 32 and 64bit, Kodibuntu boots without getting stuck on grub, but I don't get a picture through my hdmi switch, only when connected directly to my display. I do use the headless firmware, but that shouldn't matter, and my Asus works fine.

edit3: Exchanged the HDMI cable, works fine now. I vaguely remember someone else had the same problem when updating the firmware..any reason why the Chromebox is more sensitive to cable issues now, and why it only is a problem with the HP?

so both boxes hooked to the same switch/display? And have different behavior?