2019-02-07, 04:06
To the folks who have had success with adding the pci=nomsi command line in my syslinux.cfg for a Chromebox, I am having no luck (I've tried it as pci=nomsi, 'pci=nomsi', "pci-nomsi"). The problem is that each time I add the parameter using nano and LE reboots, it thinks it is a new installation and I have to go through the setup wizard again - thus not taking effect. Any advice is appreciated, thanks!
I followed the steps from the Kodi Wiki...
ssh root@<ip address>
<enter password, default is 'libreelec'>
mount -o remount,rw /dev/sda1 /flash
(Note: use /dev/sda6 for dual-boot setups)
nano /flash/syslinux.cfg
(Note: may be 'extlinux.conf' on some setups)
<add ' pci=nomsi' after 'quiet'>
<save and quit: CTRL+o CTRL+x>
reboot
I followed the steps from the Kodi Wiki...
ssh root@<ip address>
<enter password, default is 'libreelec'>
mount -o remount,rw /dev/sda1 /flash
(Note: use /dev/sda6 for dual-boot setups)
nano /flash/syslinux.cfg
(Note: may be 'extlinux.conf' on some setups)
<add ' pci=nomsi' after 'quiet'>
<save and quit: CTRL+o CTRL+x>
reboot