[Warner306]

Nope. 23.976.

What I don't understand is when I use these settings below from the configure page, I get 20 - 30ms of lag using D3D9 or D3D11. Surely it should be better than that considering I have a HD4000, not a 3000!

"I have a laptop with an Intel HD 3000 graphics processor and Sandy Bridge i7. I can run madVR with the following settings:
Chroma: Bicubic100 + AR
Image: Lanczos3 + AR
Image doubling: Off
Upscaling refinement: Off
Artifact removal - Debanding: Off
Image enhancements: Off
Dithering: Ordered"

Something sounds wrong. That is 23.976 SD -> 1080p. Try turning off Fullscreen exclusive mode and hardware acceleration.

Ah ok. What is a reasonable value you would be comfortable? 10ms / 20ms?

I guess I can't expect the same downscaling 4K to 1080p.

Exclusive mode from the DSPlayer settings and changing Kodi's render method to software you mean? It was on Auto, should I change to DXVA?

EDIT: DXVA gets it down to 1ms using D3D9.

According to the guide, Intel's DXVA scaling is similar to Lancoz 3 + AR anyway?

I'm watching a streaming game and those settings are 32.86 ms with HD3000 SD -> 1080p at 29.97 fps. DXVA is a lower quality, which is why the queue is so low. It is best with Intel iGPU. I'm not sure if you get dithering and and the output and processing is done at 8-bits rather than 16-bit. But the outcome would be identical to Kodi DVDPlayer.

Edit: I see now. At 720p, the queue goes way up. The number of pixels matters. I didn't know that. I'll add that info to the set-up guide tomorrow. Obviously, I don't have a 4K display.