[Sayajin]

So currently I am not using any Hardware acceleration at all in LAV. "None" is selected.

watch gallery

I have also previously disabled refresh rate switching in Kodi.

Warner, I have updated the display modes previously as well after reading a separate post by you.

watch gallery

Any other suggestions?

Also, regarding your question about refresh rate, I don't know if it is related, however for me to get videos to play in 60fps on the rare occasions they do play, I have to enter windowed mode and then back to full screen. I also still have the problem where about 10% of the right side of my screen is off of the display. Going to windowed mode and back fixes this as well. I have done the screen configuration and scaling options in Kodi with no success to fix this issue. I have added another log file below to show what happened. In this case, the video did play and I just had to go to windowed mode and back to get correct FPS and display scaling.

http://pastebin.com/mg49DcTR


-Sayajin

So after weeks of trying different settings and messing with stuff, I am turning here for help. I have been unable to successfully run DSPlayer without it continually crashing and giving me errors since day 1. I am confident the issue is with DSPlayer and not MadVR as MPC-HC runs flawlessly with MadVR.

I have tired multiple versions, 32bit and 64bit, multiple installs, multiple settings, DX9 instead of 11, no fullscreen exclusive and everything else I can think of.

Essentially, I load Kodi, play a file and 60% of the time the application crashes, freezes, or displays no picture and freezes but has sound. I have attached a pastebin file for analysis. I am at a loss as to the issue and am close to giving up hope. Please review the log and advise.

http://pastebin.com/CZqJaetr

http://pastebin.com/h8FpC6H1

I'm no expert on crash reports, but:

21:30:25.445 T:7284 DEBUG: CRenderDSManager::Configure - change configuration. 1920x1080. display: 1920x1080. framerate: 23.81.
21:30:26.445 T:7284 WARNING: CRenderDSManager::Configure - timeout waiting for configure

Two questions - what are you using in Lav Video - Cuda, Native or copy back? Try copy back if not already using. And, have you disabled refresh rate change in Madvr and enable in Kodi? With a 4k display,not sure why its trying to switch to 1080p...and that framerate looks odd.

K

Focus on madVR display modes and turn off refresh rate matching in Kodi. You want to add: 2160p23, 2160p24, 2160p50 and 2160p60.