2015-05-30, 20:29
I am currently runnong OE5.0.8 on a NUC celeron 2820
I use VDR to get live DVB-T TV
VDR version 1.3.0(Protocol: 8)
Every so often, Live TV freezes, causing the entire system to eventually crash and needing a reboot
After freeze I can restart watching Live TV, but it will freeze again after only a few seconds
The following message repeats every time I retry to watch live TV:
I use VDR to get live DVB-T TV
VDR version 1.3.0(Protocol: 8)
Every so often, Live TV freezes, causing the entire system to eventually crash and needing a reboot
After freeze I can restart watching Live TV, but it will freeze again after only a few seconds
Code:
-- Logs begin at Thu 2015-05-28 07:44:44 CEST. --
May 28 19:35:17 NUC vdr[1998]: [1998] DVBAPI: 0.0: status 'ready'
May 28 19:35:17 NUC vdr[1998]: [2047] DVBAPI: 1.0: status 'ready'
May 28 19:35:17 NUC vdr[1998]: [2047] DVBAPI: CaInfo: 1.0 sending CA info
May 28 19:35:17 NUC vdr[1998]: [2046] DVBAPI: CaInfo: 0.0 sending CA info
May 28 19:35:18 NUC vdr[1998]: [1998] ERROR: no OSD provider available -
using dummy OSD!
May 28 20:44:04 NUC vdr[1998]: [2062] VNSI-Error: cxSocket::read: read()
error at 0/4
May 28 21:32:40 NUC vdr[1998]: [2310] ERROR: cLiveStreamer stream
processor thread 2313 won't end (waited 5 seconds) - canceling it...
The following message repeats every time I retry to watch live TV:
Code:
May 28 21:44:32 NUC vdr[1998]: [2500] ERROR: cLiveStreamer stream
processor thread 2503 won't end (waited 5 seconds) - canceling it...