[sam0th]

Hi,

thank you. sorry to tell that it was not enough to get it back working, and thanks again for reacting that fast!! But my problem got better. The dvbs sky card now gets a poll time out like before, BUT i can see that now with your changes it is trying to tune, because red LED is blinking while searching for channels! That was not with your older builds, before your changes there was just a green power led shining.. when i hit scan button no red LED was flashing, only after 20 reboots once, very short. That was the behavior of the patch, the card only reacted every 20 time.. now that is good as expected.

But i think the module itself has changed at some point. I can tell that with a new libreelec 7 installation i got 119 muxes and 2000 channels. in libreelec 8 there come only 50 muxes and about 700 channles. and i have to add a few muxes by hand, the tvheadend predefined doenst work. i think the card itself cant handle some frequencies with newer modules..

Edit: i installed fresh on sdcard libreelec 8.90005, then updated to milhous #925. no difference between both. sat cable works on sky receiver..
Edit2: it is scanning now... 108 muxes for now. i tried build in drivers and media build with 8.90000005 and no scan working. after upgrade to milhouse i only checked the installed media build and had no luck. now changed to build in back and the scann is running!! sorry for all shitposting, i will only tell once if it works stable when done!

thank you, how can i help you? where is paypal button?