2019-04-12, 18:17
I'm using a RPi3 B+ with a Cirrus Logic Audio Card (CLAC). The last few versions of the nightly builds that I've tried, #0407, #0410 and #0411 (I didn't try #0409 or #0410), all have a problem in that the CLAC drivers don't seem to be loaded properly until a further reboot after the update sequence ends. The problem is quite obvious as the two LEDs on the CLAC are both lit up until the extra reboot - normally for playback only the green LED is lit. A side effect of this is that the CLAC has to be re-selected as the Audio Output Device under the System/Audio output device settings, otherwise PI:HDMI is selected. Everything is OK on subsequent reboots.
Note. Hias may already have seen this on his RPi/CLAC setup.
Cheers,
John
Note. Hias may already have seen this on his RPi/CLAC setup.
Cheers,
John