[HiassofT]

I'm using a RPi3 B+ with a Cirrus Logic Audio Card (CLAC). The last few versions of the nightly builds that I've tried, #0407, #0410 and #0411 (I didn't try #0409 or #0410), all have a problem in that the CLAC drivers don't seem to be loaded properly until a further reboot after the update sequence ends. The problem is quite obvious as the two LEDs on the CLAC are both lit up until the extra reboot - normally for playback only the green LED is lit. A side effect of this is that the CLAC has to be re-selected as the Audio Output Device under the System/Audio output device settings, otherwise PI:HDMI is selected. Everything is OK on subsequent reboots.

Note. Hias may already have seen this on his RPi/CLAC setup.

I recently tested with build 0409 and now with build 0411 but everything works fine here.

Can you try to find out with which build this started and post your config.txt and dmesg from a failed start?

so long,

Hias