[jglazer63]

When I press the POWER button on my remote and LibreElec it shuts down the Raspberry Pi (as expected) but I cannot press POWER to turn it back on. I assume this is because it is going into full power-off. Is there a way to change it to SUSPEND or SLEEP or whatever instead of fully shutting down so I can turn it back on via remote?

[dandnsmith]

In a word - no.
But why would you want to, rather than just going to screensaver mode?

[Klojum]

TS's question has already been answered on the LibreELEC forum, as it was crossposted... :-|

[jglazer63]

In a word - no.
But why would you want to, rather than just going to screensaver mode?

Well if you have drives connected and it goes into suspend mode the drives will spin down.

[aytek]

In a word - no.
But why would you want to, rather than just going to screensaver mode?

Well if you have drives connected and it goes into suspend mode the drives will spin down. 

Looking for the same reason. Is there a solution to that? Otherwise my libreelec wakes my NAS every 30 minutes for no reason even I am not using it.