2020-01-10, 23:19
So I feel a bit ignorant about this stuff but I'm also genuinely confused as to why I can't figure out a simple solution to this. I feel like maybe I just need to add a line to the config.txt or something? But I'm not sure what that line is.
I have a Raspberry Pi 4 connected to a low-end projector via HDMI.
If I start it with the HDMI cable unplugged and wait for KODI to boot everything is great. And the resolution in Kodi is 1024 x 768 (which is what I set it to). But if I boot it with the HDMI cable plugged in, the first boot screens show up and then the point at which KODI would show up just displays a blank black screen. At this point KODI is running, I can navigate and reset the unit with my remote, but the display is just blank. I would assume the resolution has switched to something my projector can't handle.
I feel like there's some sort of HDMI detection going awry but I can't find how to disable it?
I swear I tried googling about this issue. Thanks!
I have a Raspberry Pi 4 connected to a low-end projector via HDMI.
If I start it with the HDMI cable unplugged and wait for KODI to boot everything is great. And the resolution in Kodi is 1024 x 768 (which is what I set it to). But if I boot it with the HDMI cable plugged in, the first boot screens show up and then the point at which KODI would show up just displays a blank black screen. At this point KODI is running, I can navigate and reset the unit with my remote, but the display is just blank. I would assume the resolution has switched to something my projector can't handle.
I feel like there's some sort of HDMI detection going awry but I can't find how to disable it?
I swear I tried googling about this issue. Thanks!