Thanks everyone for help posting the fix for this version.
I'm not sure why this is happening, having SMB should be standards and I don't know why it is getting more complicated each time.
This is the step I took and got it to working.
- Go to setting > service
- Enable Expert mode
- Set min requirement to SMBv1 (you need to restart and come back)
- Set max requirement to SMBv1 (you need to restart and come back)
At this stage you will be able to connect SMB now but got stuck in user/pass. This doesn't work with non-user/pass folder.
If you want to access the folder then do the step below:
- After the above setting, Now Legacy mode will be available turn it ON (you need to restart and come back)
- DONE!
Now if you have the previous folder configuration, then this should fix it for you immediately.
But if you are new user, then you need to re add the directory again (smb://YOUR server IP) and then go in and add each shared folder one by one.
Also on the step above I did setup the workgroup to be the same one as my server and also setup WINS server to the same IP address as my router/gateway.
That's it, hope this help.
Hope this help.