2009-01-29, 02:49
davidw Wrote:I changed the toggle_bit_mask back to the "defaults" from irrecord but I still have the same problems that sometimes there are no signals AND irw and xbmc recognizes two signals on one button press.
Hmm, the only advice I can give you is to rerecord your buttons. I had to rerecord mine, too because on the first recording my remote was too close to the receiver. Try to record your buttons again and keep a distance from the receiver.
Quote:So I think it's not the toggle_bit_mask but can you tell me how I can tell XBMC that it should ignore the second signal?
My XBMC version does this on its own. My remote has a really high repeat rate, too but XBMC just reacts once. Only if I hold the button down, the action gets repeated.
Quote:Maybe the problem is that I must use two lirc configurations!?
I'll try to configure it to one but last times I failed!
You only need two different lirc configs if your remote is split into two parts like the RM200.