2011-03-12, 20:43
I think i may be going mad here, but hopefully somebody may be able to help.
I thought that my set-up of Neon worked in the following way:
I'm using the AppleTV (1stGen) with the very limited remote.
1. Select Movies from the home screen.
2. Scroll through movies until desired film is highlighted.
3. Press the play button.
4. The Movie Information screen appears, showing Play, Trailer, Cast, Refresh, Get Thumb etc...
5. Then select Play from the list and the movie plays.
I had my modem/router upgrading to 50Mb this morning and had to reset the network settings on everything.
Now whenever i press Play from the Movies screen (point 3 above), the movie plays without the info/cast.
I would really like to get it back the way it was but can't figure out / remember how to do it.
Any help would be greatly appreciated.
I thought that my set-up of Neon worked in the following way:
I'm using the AppleTV (1stGen) with the very limited remote.
1. Select Movies from the home screen.
2. Scroll through movies until desired film is highlighted.
3. Press the play button.
4. The Movie Information screen appears, showing Play, Trailer, Cast, Refresh, Get Thumb etc...
5. Then select Play from the list and the movie plays.
I had my modem/router upgrading to 50Mb this morning and had to reset the network settings on everything.
Now whenever i press Play from the Movies screen (point 3 above), the movie plays without the info/cast.
I would really like to get it back the way it was but can't figure out / remember how to do it.
Any help would be greatly appreciated.