2015-12-31, 00:16
Following is my setup:
* Yamaha RX-765 AV amplifier
* Raspberry-PI 2 connected to.amplifier with HDMI cable
* HDMI CEC is enabled on amplifier
* KODI v15.2 is running on R-PI
* KODI is controled by Yatse v5.9.5
When I press Volume Up/Down buttons in the Yatse, it changes volume on AV amplifier (using HDMI CEC commands, I believe).
If I establish SSH session with R-PI, run cec-client application and then close it, I cannot change volume on amplifier with Yatse. It changes volume of the KODI only.
Looks like somehow cec-client disconnects KODI from HDMI CEC bus.
* Yamaha RX-765 AV amplifier
* Raspberry-PI 2 connected to.amplifier with HDMI cable
* HDMI CEC is enabled on amplifier
* KODI v15.2 is running on R-PI
* KODI is controled by Yatse v5.9.5
When I press Volume Up/Down buttons in the Yatse, it changes volume on AV amplifier (using HDMI CEC commands, I believe).
If I establish SSH session with R-PI, run cec-client application and then close it, I cannot change volume on amplifier with Yatse. It changes volume of the KODI only.
Looks like somehow cec-client disconnects KODI from HDMI CEC bus.