2011-01-03, 17:29
@wicked_n_raw
127.0.0.1 should not be an issue if you are using a single machine... if you are using multiple machines it might be I need to read up on that a bit but there should be no issue with the address being 127.0.0.1 on a single machine.
The worst case scenario will be that the system will try and access the files on 127.0.0.1 (localhost (this machine)) in an attempt to reach the files. As the whole thing is contained on a single machine this should not be an issue.
To prove this to my self I have played back a movie and a first episode of a series which worked fine. So I am sure that 127.0.0.1 will not be an issue when using a single fully self contained machine (all files, database and XBMC on one machine) Remember I was using a test system not my actual setup as I rather mess up a test system then a perfectly tuned to my wishes main HTPC
But you are saying clear the whole database before you start... that sounds plausible (I have tried that but not with a clean install yet).
I'll try that this evening and post an update on how that worked out.
127.0.0.1 should not be an issue if you are using a single machine... if you are using multiple machines it might be I need to read up on that a bit but there should be no issue with the address being 127.0.0.1 on a single machine.
The worst case scenario will be that the system will try and access the files on 127.0.0.1 (localhost (this machine)) in an attempt to reach the files. As the whole thing is contained on a single machine this should not be an issue.
To prove this to my self I have played back a movie and a first episode of a series which worked fine. So I am sure that 127.0.0.1 will not be an issue when using a single fully self contained machine (all files, database and XBMC on one machine) Remember I was using a test system not my actual setup as I rather mess up a test system then a perfectly tuned to my wishes main HTPC
But you are saying clear the whole database before you start... that sounds plausible (I have tried that but not with a clean install yet).
I'll try that this evening and post an update on how that worked out.