2013-06-03, 19:36
(2013-06-03, 19:31)pseudoheld Wrote: I can't get boblight to work!
im running on windows 8 with 50 ws2801 hooked up to an arduino uno.
when i start boblight the colorswirl goes of and it says setup succeeded but after that i can't get it working. neither via xbmc plugin or via bobdroid.
here is my boblight.conf
i set the output to com3 (which is correct)
is the channels and type correct?
Code:#[global]
interface 127.0.0.1
port 19333
[device]
name ambilight
output /dev/com3
channels 150
type atmo
interval 10000
prefix FF
rate 115200
[color]
name red
rgb FF0000
gamma 0.91
adjust 1.0
blacklevel 0.0
[color]
name green
rgb 00FF00
gamma 0.86
adjust 0.96
blacklevel 0.0
[color]
name blue
rgb 0000FF
gamma 0.95
adjust 0.8
blacklevel 0.0
also here is the output of the boblight window with me starting xbmc (xbmc saying boblight connected) and then starting a movie...
any ideas whats wrong
Your prefix is wrong. This should do it, I guess: 416461003164
Also, you should configure 150 LEDs, not only 50. (Red, Green, Blue)
Use this calculator:
http://sanya.tarhelyszolgaltato.eu/
And read here:
http://forum.xbmc.org/showthread.php?tid=116331&pid=1059881#pid1059881