2016-06-09, 01:15
Thanks Milhouse you legend
(2016-06-09, 14:18)PuGZopf Wrote: Hello All,
My first post an directly an issue... :-(
Yesterday I´ve installed LE 7.xx on my PI2. All is workink fine. Then I tried o Update to the lasted Build from LE from Milhouse, The update runs fine, On my via HDMI connected TV I see alle messages, unpack install etc. Then the Mashine reboots.
The Boot screen is shown and after this....: all is Black. I can´t access the PI2 via RemoteControl ( like it does before )
I Can access the LE 8 vie HTTP and vie SMB I can put into the Update folder other Update Files. They are taken into account, but after the installation the TV is still black.
Only with LE 7 all is fine.
My TV is a Samsung 6xxx Series TV
Has any one a idea? where should i find logs etc??
Zopf
(2016-06-09, 14:54)kieranc Wrote: Edit: Pi3 using built in bluetooth. I've not tried a full wipe yet, but can if it's expected to resolve the problem.
systemctl stop kodi
mv .kodi .kodi.bak
sync; reboot
# uname -a
Linux rpi512 4.6.2 #1 Thu Jun 9 21:10:22 BST 2016 armv6l GNU/Linux
# vcgencmd version
Jun 8 2016 16:12:00
Copyright (c) 2012 Broadcom
version 1c8638223821fe0ed16e20bd8e948b6cc037fa4a (clean) (release)
# lsb_release
LibreELEC (Milhouse) - Version: devel-20160609210740-#0609-g61dbf48 [Build #0609]
# vcdbg log msg 2>&1 | grep DTOK
002475.631: Kernel trailer DTOK property says yes
# Kernel device tree status: Enabled
(2016-06-09, 20:39)doldi Wrote: Sorry for my last post - my mistake.
cu
Harald
(2016-06-10, 06:09)donlasagne Wrote: Hey Milhouse i can't save my settings in the LibreELEC Settings Add-on. There is only a Cancel Button.
(2016-06-10, 14:32)unclejoe01 Wrote: I have a problem when i turn off my TV, and then turn it back on, KODI doesn't wake up or the TV stays on black screen. I am connecting with HDMI and using the TV remote with CEC. I have added hdmi_force_hotplug=1 and hdmi_drive=2 in the config but it still goes to blank screen after turning off and then on the TV. Any ideas? Using raspberry pi 3.
(2016-06-10, 15:11)popcornmix Wrote:(2016-06-10, 14:32)unclejoe01 Wrote: I have a problem when i turn off my TV, and then turn it back on, KODI doesn't wake up or the TV stays on black screen. I am connecting with HDMI and using the TV remote with CEC. I have added hdmi_force_hotplug=1 and hdmi_drive=2 in the config but it still goes to blank screen after turning off and then on the TV. Any ideas? Using raspberry pi 3.
What do you have "When TV is switched off" set to (in system/input/peripherals/CEC)?
(2016-06-10, 18:50)cojms1 Wrote: Recently I've been getting an issue with Live TV (pvr.hts) where the picture is very juddery. When I go into the video settings and turn Deinterlace settings from Auto to Off all seems fine.
I've gone back through the versions; #0604 is fine and #0605 exhibits the problem.