2011-02-23, 20:00
The steps of defcon are incorrect
You need the new files and the procedure is on the googlecode for CrystalHD
You need the new files and the procedure is on the googlecode for CrystalHD
ifreezer Wrote:I have installed the Crystal Broadcom 00015 board in my ATV1. I have XBMC 10.1 installed, with the latest nightly. I downloaded the r174 crystal driver with Launcher and it installed successfully. However, when I look through the menus in XBMC I do not see any mention of the new processor. Am I supposed to see a place in the Settings to enable the accelerator?
How can I determine if the board is detected and in use?
Thanks in advance.
Hudson_Hawk04 Wrote:after installing the drivers via the launcher you will need to do a restart then upon re entering xbmc the hardware acceleration via crystalhd card (or something like that) should be enabled.I have restarted several times.
Hudson_Hawk04 Wrote:there is a menu item at system---video----play back it should be checked ie you are using the device.
ifreezer Wrote:I have installed the Crystal Broadcom 00015 board in my ATV1. I have XBMC 10.1 installed, with the latest nightly. I downloaded the r174 crystal driver with Launcher and it installed successfully. However, when I look through the menus in XBMC I do not see any mention of the new processor. Am I supposed to see a place in the Settings to enable the accelerator?I have installed the Crystal Broadcom 00015 board in my ATV1, as well as you!
How can I determine if the board is detected and in use?
Thanks in advance.
ifreezer Wrote:I have installed the Crystal Broadcom 00015 board in my ATV1. I have XBMC 10.1 installed, with the latest nightly.