2011-04-04, 23:52
Sorry, kind of new to the xbmc. I installed 4.3 (untethered) on the ATV2 today, and I get audio, error message: failed to initialize audio device. I have checked the audio settings, and altered them a few times-right now I have it set as
Audio out Optical/coax (bc I have the optical audio wire for AV2)
Speaker config 5.1
Boost Vol checked
AC3 Checked
DTS Checked
Default audio output
I believe I am on Darwin 11.0
I don't know if installing the most current nightly will fix this or if this is just a bug that needs to be ironed out. Either way, I have been searching for hours and can find no directions on how to install the nightly builds, can anyone help.
Audio out Optical/coax (bc I have the optical audio wire for AV2)
Speaker config 5.1
Boost Vol checked
AC3 Checked
DTS Checked
Default audio output
I believe I am on Darwin 11.0
I don't know if installing the most current nightly will fix this or if this is just a bug that needs to be ironed out. Either way, I have been searching for hours and can find no directions on how to install the nightly builds, can anyone help.