2012-03-13, 10:49
The tvheadend main site is pretty much a dead zone as far a info. The documentation and forum is non where near the caliber of xbmc. I'm spoiled.
ubuntu 11.10
tvheadend-pulse 2.12.99
pci hdtv tuner
Comast cable - Soon to be a cable card, but want to see how QAM worked
Below is the steps after creating access control and DVR. Next step is
Configuration
Selecting Video Card: Samsung S5H1409 QAM/8VSB Frontend
Just have Idle scanning set and saved.
Services:
0
Muxes:
124
Muxes awaiting initial scan:
122
After scan
Services:
455
Muxes:
124
Muxes awaiting initial scan:
0
Map DVB Services to channels, nothing happens. The services tap lists all the services, unmapped, but no channels ids. The multiplexers tab lists muxids and signal strengths but no listed channels.
Any advice. I also re-did and selected auto-scan with cable mid-freq with similar results.
ubuntu 11.10
tvheadend-pulse 2.12.99
pci hdtv tuner
Comast cable - Soon to be a cable card, but want to see how QAM worked
Below is the steps after creating access control and DVR. Next step is
Configuration
Selecting Video Card: Samsung S5H1409 QAM/8VSB Frontend
Just have Idle scanning set and saved.
Services:
0
Muxes:
124
Muxes awaiting initial scan:
122
After scan
Services:
455
Muxes:
124
Muxes awaiting initial scan:
0
Map DVB Services to channels, nothing happens. The services tap lists all the services, unmapped, but no channels ids. The multiplexers tab lists muxids and signal strengths but no listed channels.
Any advice. I also re-did and selected auto-scan with cable mid-freq with similar results.