2014-01-02, 21:25
Hi, I hope someone can help or point me in the right direction.
I've installed tvheadend v3.4.27 and was able to connected successfully to my tvcard. I am running Ubuntu 13.10.
Under xbmc I looked for settings - addons - to enable my pvr client as most installation guidelines seem to state that pvr addons are installed by default. Going round in circles a few times, today I added the pvr addon manually from a zip file (pvr.hts-linux-x86_64.zip) and I was able to configure it with local host and user name and password.
But immediately a message appears stating TVheadend HTSP client: connection lost.
What is this, as I am able to log into the tvheadend admin web page successfully with the same credentials.
So close and yet so far.
Thanks, Frank
oh, the xbmc log file shows this
I found another post in this forum http://forum.xbmc.org/showthread.php?tid=121353&page=2 suggesting to:
In tvheadend, go into Access control and in the User and Password boxes just put a * and enable streaming. Save that, then go into xbmc and just delete the username/password entries. It should then connect straight up .
Makes no change. Still the same failed authentication.
I've installed tvheadend v3.4.27 and was able to connected successfully to my tvcard. I am running Ubuntu 13.10.
Under xbmc I looked for settings - addons - to enable my pvr client as most installation guidelines seem to state that pvr addons are installed by default. Going round in circles a few times, today I added the pvr addon manually from a zip file (pvr.hts-linux-x86_64.zip) and I was able to configure it with local host and user name and password.
But immediately a message appears stating TVheadend HTSP client: connection lost.
What is this, as I am able to log into the tvheadend admin web page successfully with the same credentials.
So close and yet so far.
Thanks, Frank
oh, the xbmc log file shows this
Quote:19:43:27 T:140283295561472 NOTICE: AddOnLog: Tvheadend HTSP Client: CHTSPConnection - SendGreeting - connection opened to 'HTS Tvheadend 3.4.27~gfbda802~raring', protocol v10
19:43:27 T:140283295561472 ERROR: AddOnLog: Tvheadend HTSP Client: CHTSPConnection - Auth - failed to get a reply from the auth command
19:43:27 T:140283295561472 ERROR: AddOnLog: Tvheadend HTSP Client: Connect - failed to authenticate
19:43:27 T:140283295561472 ERROR: AddOnLog: Tvheadend HTSP Client: ReadResult - 'enableAsyncMetadata' failed - not connected
19:43:27 T:140283295561472 ERROR: AddOnLog: Tvheadend HTSP Client: Open - couldn't send EnableAsync().
19:43:27 T:140283295561472 ERROR: ADDON: Dll Tvheadend HTSP Client - Client returned bad status (1) from Create and is not usable
19:43:27 T:140283295561472 WARNING: UpdateAndInitialiseClients - failed to create add-on Tvheadend HTSP Client, status = 1
I found another post in this forum http://forum.xbmc.org/showthread.php?tid=121353&page=2 suggesting to:
In tvheadend, go into Access control and in the User and Password boxes just put a * and enable streaming. Save that, then go into xbmc and just delete the username/password entries. It should then connect straight up .
Makes no change. Still the same failed authentication.
