2015-04-16, 12:46
(2015-04-16, 08:51)mcgyver83 Wrote: Hi, I have only the raspberry attached to the TV.
Since the gotham release I was using the remote controller; 6 months ago I started with a fresh image and this is the first time I install xbmc on it.
Try unplugging the TV from the mains for a minute. Surprisingly this often gets CEC working (TVs seem to "remember" unwanted stuff about past CEC devices connected)
Make sure TV was powered up first and on correct HDMI input before Pi was booted.
Some HDMI cables don't wire the CEC pin. Are you sure that cable works with CEC?
It might be worth an experiment with an OpenELEC install where we know that libcec is built correctly just to prove the Pi/cable/TV are set up correctly.
