[MariusB]

Hi Milhouse/All

I have Intel NUC Kit NUC5CPYH and I currently am using #0506 build which I really like.
With few last OpenElec builds and some LibreElec builds I tried I am facing the same problem described below:
I am controlling my devices using Logitech Harmony remote and my NUC5CPYH is always on (I need it to be accessible all time) and all other devices: AV receiver (HDMI pass trough), TV are switched off when not used.
After certain time of inactivity when I turn on this activity on my remote I got a blank black screen instead of seeing KODI interface which has to be always on (where I left it). On some earlier builds there was a blank screen and just a mouse cursor visible on it (I am not using a mouse). The only thing I can do is to restart the NUC device by pressing On/Off on NUC or telnet to it and reboot. Apart from this issue everything else works fine.
I used clean install using official LibreElec build and only few changes are done to the standard configuration: change of Time zone, Audio pass-through via HDMI, adjust fresh rate on start/stop, full colour space enabled, enable ssh and few others.

I have uploaded my log file here: http://sprunge.us/KPNB but I made this log after restart of the system so not sure if it helps but I can upload a new log when system crashes again before restart because as I wrote I am able to telnet to it.
Can you please help me with this?

Thanks,
Marius