Thread Closed
v18 LibreELEC Testbuilds for x86_64 (Kodi 18.0)
(2018-04-30, 16:13)TheKraut Wrote: Remote control via Yatse still works perfectly afterwards. I've tested various builds between #0405 and #0429, but the problem persists. A reboot solves the problem, just for the game to begin again after a couple of key presses.

To cross check, I ran Ubuntu 18.04 LTS from a pen drive, and observed the very same behavior. Interestingly, when I created a #0405 bootable disk, remote control works perfectly fine within the LE installer, so my educated guess is that the issue is not hardware related.
So does this mean #0405 in "Live Mode" from the bootable disk works fine, but when you install #0405 on your NUC it doesn't work?

If yes, do you have any manually setup config files (autostart.sh, lircd.conf, rc_maps.cfg, kodi advancesettings.xml etc) on your system?

so long,

Hias
  Thread Closed
 
Thread Rating:
  • 24 Vote(s) - 4.5 Average


Messages In This Thread
RE: LibreELEC Testbuilds for x86_64 (Kodi 18.0) - by HiassofT - 2018-04-30, 19:28