[User 413466]

- RC not working: LE #0405, #0429 (and a couple of versions in between) when installed
- RC not working: LE #0429 when run in live mode (KODI log in my original post above; didn't bother to test any other version)
- RC not working: Ubuntu 18.04 LTS in live mode
- RC working: #0429 when booting to text-based installer

By "not", I mean more specifically: It is working for a seemingly random, double digit number of key presses after a reboot. Then, it ceases to work.

No manual config files in either configuration.

I was guessing on a kernel problem with 4.14/4.15. However, given that the installer works fine, it may well be UI related (and shouldn't be hardware related, I presume).

It would be good to know the first build where IR stopped working, so please also test builds before 0405. Several IR changes were added in build 0328, so checking builds 0327 and 0328 would be a good start. If build 0327 doesn't work either please check earlier builds as well.

so long,

Hias 

So, I tested #0327 and #1119, since #1120 mentions a major kernel-related IR change. Same issue for both versions, RC stops working after a couple of key presses.

The Harmony also allows to adjust a few device-specific properties: For the NUC, I now set key repetitions to 0 and slowly increased "key delay" and "device delay" to 1000 ms each. Still, the problem persists.

I'm a bit puzzled at this point. Remote still works fine for any other device, and since a reboot temporarily solves the problem, there is a strong indication for a software issue, right?