(2019-10-08, 17:04)popcornmix Wrote: Out of the box, Pi4 supports up to 1080p60 and 4kp30.
To enable 4kp60 you need to add hdmi_enable_4kp60=1 to config.txt.
I suspect your smooth TV is choosing 1080p60 and the not smooth one is choosing 4kp30
and you are seeing a problem with the lower framerate.
Either change the resolution in the GUI to 1080p (which will allow the higher framerate)
or add hdmi_enable_4kp60=1 to config.txt.
4kp60 isn't enabled by default as it requires higher clock frequencies and runs a little warmer.
I have added it.
My config.txt looks like this now:
# SPDX-License-Identifier: GPL-2.0-or-later
# Copyright © 2009-2014 Stephan Raue (
[email protected])
# Copyright © 2016-present Team LibreELEC (
https://libreelec.tv)
################################################################################
# Bootloader configuration - config.txt
################################################################################
################################################################################
# Memory (System/GPU configuration )
################################################################################
# Default GPU memory split - at least 288M is needed for some 4k HEVC files
gpu_mem=320
################################################################################
# For overclocking and various other settings, see:
#
https://www.raspberrypi.org/documentatio...fig-txt.md
################################################################################
# Set 'force_turbo=1' to disable dynamic overclocking and enable overclocking always.
force_turbo=0
# Force HDMI even if unplugged or powered off
# hdmi_force_hotplug=1
# Doesn't sent initial active source message.
# Avoids bringing CEC (enabled TV) out of standby and channel switch when
# rebooting.
hdmi_ignore_cec_init=1
hdmi_enable_4kp60=1
################################################################################
# End of default configuration
################################################################################
################################################################################
# Include distribution specific config file if it exists.
################################################################################
[all]
include distroconfig.txt