2021-01-03, 08:04
(2021-01-03, 05:11)fandangos Wrote: This is very setup dependent as we know but I've tested 20 Dolby Vision remux and I had 99% of success if I set delay refresh rate change to 11 seconds and set it to start/stop.By different setup do you mean the different TVs (and HDMI splitters) involved? The firmware on Shield Pro on all cases were the same I believe (8.2.1) and we were all running the same samples but the TVs had different levels of DV support. BTW, I am still running your build from 12/22 - does the latest nightly have your changes?
If the loading symbol showed up as if it was about to fail, when the refresh kicks in, it starts the movie.
Also enabling match refresh rate (beta) on the shield, disabling refresh rate change on kodi and using it, also produce good results.